產品分類

產品：Hi-Flo 3e - WQA Gold Seal for ANSI/NSF Standard 61 Automatic Water Softener
編號：110621085015
品牌：PENTEK

產品簡介

詳細規格

Functions:
Cost savings, increased equipment life, scale reduction, reduced labor, longer linen life, and spot-free results.
Applications:
?  Make-up water for boilers
?  Cafeteria-food service
?  Classroom Labs
?  Cooling towers
?  Pools
?  Ice Machines
?  Vending machines
?  Fountain Service
?  Drinking water
?  Facility Use
?  Vehicle Wash

Options:　 ? Dubl-Safe Brine System - Positive overfill protection.  Automatic refill control is backed up by shutoff float valve to minimize chance of overflow. ? Patented Progressive Flow - Culligan's MVP Control can monitor flow demands bringing additional softening tanks on-line or offline as flows increase or decrease. ? Flow Measuring Devices - are available for direct connection to the MVP controller for volume based regeneration initiation. 　 Standard Features:　 ? Simple mechanical controls 　 ? Positive Motor-Driven regeneration 　 ? Automatic Brine Control 　 ? Corrosion Resistant Tanks 　 ? Single or multiple tank configurations 　 ? Time clock or meter regeneration initiation 　 　 System Specifications:　 Pressure : 30-125 psi　 Power Supply : 24 Volts 50/60Hz Power Consumption : 3/100 Watts Min/Max　 Vacuum : none Temperature : 4 - 38oC　 Turbidity : 5 NTU, max. Chlorine : 1 mg/L, max. Iron : 5 mg/L　 120 Volt / 24 Volt CUL/UL listed Transformer Included. Tank warranty is void if subject to vacuum. See media specification for details.
Model	Resin Qty (Ft)	Pipe Size	Flow Rates (gpm)		Tank Size***
			Continuous*	Peak**	Softener	Brine****
HCE-120-2	4	2"	45	60	16 x 65	24 x 48
HCE-150-2	5	2"	60	78	21 x 54	24 x 48
HCE-210-2	7	2"	58	76	21 x 69	24 x 48
HCE-300-2	10	2"	65	85	24 x 72	30 x 48
HCE-450-2	15	2"	75	100	30 x 72	30 x 48
* Flow rate at a 15 psi pressure loss.
** Flow rate at a 25 psi pressure loss.
*** Dimensions are diameter by tank height.
**** Brine systems are optional.  Size shown is size most commonly selected.
Flow rate shown are per tank. Low flow channeling (flow rates less than 0.5 gallons per minute per cubic foot of resin) may cause hardness leakage into effluent.